| Training Courses |
|
FDOT Advanced GEOPAK for Roadway Designers
2 days — $900
This course follows the Basic GEOPAK for Roadway Designers class in continuing to learn Roadway design to FDOT Standards. Topics covered include: DTM Tools, existing Ground Profiles & Cross Sections, Proposed Profile, Proposed Cross Section, Active Chain Control, Earthwork, Cross Section Reports and Sheets.
Major Concepts Covered:
- Extract Existing TIN from a 3D Graphics Triangle File
- Display TIN
- Cut Existing Profile from TIN
- Plot Profile in a file using Road Manager and as an Alternate Method, using Design & Computation Manager
- Detail Pattern Lines
- Draw Pattern Lines
- Detail Existing Ground Cross Sections
- Draw Existing Ground Cross Sections
- Plot Existing Sub Base
- Plot Existing Utilities
- Detail Profile Generator and Component Profile Tools
- Create Proposed Profile
- Plot Profile into Profile View
Detail Active Chain Control including setup
- Superelevation Tools
- Build Superelevation Shapes
- Analyze Shapes
- Detail Proposed Cross Section using Typical Section Generator
- Draw Proposed Cross Sections using Project Managers Proposed
Cross Section Tool (runs)
- Run Quantities for Earthwork
- Create Earthwork Output File
- Cross Section Report Tools
- Limits of Construction
- Creating GEN Files
- Overview Cross Section Sheet Layout using Models
- Layout Cross Section Sheets with Quantities
Most of the above will be done through Project Manager using Active Working Alignment. The working alignment definition will be updated through each phase of development towards the completion of the proposed cross sections.
Prerequisites: Completion of the Basic GEOPAK for ROADWAY Designers course |
